
17
Malfunction, cause and remedy
17.5
Faults of the electrics/electronics
218
Comprima V 180
Original Operating Instructions 150001053_00_en
522040-
Round bale in the bale chamber
Possible cause
Remedy
FMI 0: There is a filling problem. The round bale in the bale chamber is too small on the right-
hand side.
Extremely uneven filling of the
bale chamber. More crops
were fed in on the left side
than on the right side.
Fill the bale chamber more evenly.
Drive more slowly at the end of the round bale.
Check and adjust sensor B10 “Filling display right”,
522041-
Round bale in the bale chamber
Possible cause
Remedy
FMI 0: There is a filling problem. The round bale in the bale chamber is too small on the left-
hand side.
Extremely uneven filling of the
bale chamber. More crops
were fed in on the right side
than on the left side.
Fill the bale chamber more evenly.
Drive more slowly at the end of the round bale.
Check and adjust sensor B09 “Filling display left”,
522044-
Tailgate
Possible cause
Remedy
FMI 2: When moving to a position, the current position of the tailgate could not be determined.
The sensors are defective or
have been incorrectly set.
Check and set the following sensors,
:
• Sensor B11 Lock hook bale chamber left
• Sensor B12 Lock hook bale chamber right
There is a mechanical fault at
one of the sensors.
Contact the KRONE service partner.
522046-
Tailgate
Possible cause
Remedy
FMI 7: The tailgate could not be closed within the stipulated time.
The sensor is defective or has
been incorrectly set.
Check and set the sensors B11/B12 "Lock hook bale
chamber left/Lock hook bale chamber right",
The tailgate mechanically
blocked.
Remove the blockage, e.g. crops.
The tailgate stop cock locks
the hydraulics.
.
The hydraulic pressure is not
adequate.
Check whether the rotational speed of the universal shaft is
adequate and increase if required.
522047-
Tailgate