Terminal menus
13
Menu 15 "Settings" 13.20
Comprima V 180
Original Operating Instructions 150001053_00_en
135
13.20.1.1
Adjusting sensor B09/B10 “Filling display left/right”
3
B08
B09
L
B10
R
1
state:
15-1
2,4V
1,9V
3,2V
1,9V
1
2
EQG003-042
The sensor (3) is located behind the side hood:
•
B09 on the left side of the machine
•
B10 on the right side of the machine
The green bar in menu 15-1 “Sensor test” shows the saved value. The black bar shows the
current value of the sensor. As soon as a new value is saved, the green bar is adjusted to the
black one.
ü
The bale chamber is closed and empty.
ü
The density of the bale core is set in position III – “Low density of the bale core”, see
operating instructions, chapter Operation, “Adjusting the density of the bale core”.
ü
Menu 15-1 “Sensor test” is open.
ü
Sensor B09 or B10 has been selected.
If the bar (2) is not inside the rectangle (1) when the bale chamber is closed and empty, adjust
the sensor B09 or B10 mechanically:
Loosen the screw connections of the sensor and move them in the oblong hole until the
bar (2) on the display is inside the rectangle (1) of the bargraph.
ð
An acoustic signal sounds when the bar (2) is inside the rectangle (1).
Tighten the screw connections of the sensor.
Press
.
Æ
The set position is saved.
INFORMATION
Saving is only possible if the bar (2) is inside the rectangle (1) of the bargraph.
13.20.1.2
Adjusting sensor B61 “Tying 1 (passive)”
The following positions are saved with sensor B61 “Tying 1 (passive)”:
•
The feed position,
•
the cutting position and
•
the tying position.