Krone Comprima V 180, Original Operating Instructions, Page: 88 / 242

8 Operation
8.15 Removing crop blockages
88
Comprima V 180
Original Operating Instructions 150001053_00_en
The round bale is automatically conveyed from the bale chamber via the bale ejector onto the
field.
NOTICE
Machine damage due to an incorrectly positioned bale ejector
The connecting rod can be bent if the bale ejector is not positioned on the axis after ejection.
After the round bale has been laid down, the bale chamber is closed and whilst new crops are
being taken in, the bale ejector must be positioned again on the axis.
„
Have the setting of the bale ejector be checked by a KRONE service partner.
8.15 Removing crop blockages
8.15.1 Crop blockage at the right-hand and left-hand end of the pick-up
„ While the PTO shaft is running, reverse and actuate the control unit in the tractor (yellow,
3+) several times to lift and lower the pick-up.
„
Ensure that the crop press roller unit does not collide with the chassis when raised.
If this does not remove the crop blockage:
„
Shut down and safeguard the machine, refer to page 25 .
CAUTION! Risk of injury due to sharp parts! Always wear appropriate protective gloves
when removing crop blockages.
„
Remove the accumulated crops manually.
8.15.2 Crop blockage in the pick-up
„ While the PTO shaft is running, reverse and actuate the control unit in the tractor (yellow,
3+) several times to lift and lower the pick-up.
„
Ensure that the crop press roller unit does not collide with the chassis when raised.
If this does not remove the crop blockage:
„
Shut down and safeguard the machine, refer to page 25 .
„
Remove the baffle sheet, refer to page 79 .
„ Remove the accumulated crops manually.
CAUTION! Risk of injury due to sharp parts! Always wear appropriate protective gloves
when removing crop blockages.
„ Mount the baffle sheet, refer to page 79 .
8.15.3 Crop blockage in the baling element
„
Switch on the PTO shaft.
„ Open the tailgate.
„
Shut down and safeguard the machine, refer to page 25 .
„ Close the stop cock, refer to page 73 .
„
Manually remove the accumulated crops from the baling element.
„ Open the stop cock, refer to page 73 .