DCP 30 L/LX / DCP 30 S/SX
Issue: 11/2009
35
• Push on the click button
Dowser
.
$
The dowser opens. The click button appears blue.
• Push on the click button
Lamp
.
$
The xenon lamp is switched on. The click button appears blue.
$
The cinema projection starts.
Saved Macros
Because the user interface of the program can only display 8 different preset macros,
they are devised over several registers.
For selecting a register just click on it.
X
NOTE
Z
Macros can be programmed by the Communicator software and assigned to a button
(preset macro).
Z
Changing a macro can only be carried out at the service level.
Z
See chapter 5 to get more information about the Communicator software.
4 .2
Stopping / Ending the Cinema Projection Manually
• Click/Tip
on the button panel or the click button
Dowser
in Communicator to
close the dowser.
$
If the dowser is closed, the button illuminates red.
The user interface of the Communicator shows a grey dowser button.
• Click/Tip
on the button panel or the click button
Lamp
in Communicator to
switch off the lamp.
$
If the lamp is off, the button illuminates red.
The user interface of the Communicator shows a grey lamp button.
$
The status lamp on the top of the projector head illuminates green further on.
ATTENTION
Before switching off the projector by using the main switch, it is absolutely necessary
that the ventilation runs for at least 10 minutes to cool down the xenon bulb.
• After about 10 minutes switch off the projector by positioning the main switch
to
0 OFF
.
$
The green LED below the button panel goes out.
$
The optional touchscreen gets dark.
$
The status lamp on the top of the projector head goes out, the fans will be
switched off.
X
NOTE
The projector can be switched on after a waiting period of at least 30 seconds after it
was switched off.
Operation
