Kikusui PAT160-25T, Operation Manual

Page: 18 / 218

1-2
PAT-T 4kW
1.1 About This Manual
This manual describes the PAT-T Series (4 kW type), regulated DC power supply.
Applicable firmware version of the PAT
p. 2-9
This manual applies to PATs with firmware version 4.0x.
When making an inquiry about the product, please provide us with the following
information.
• Model (indicated at the top section on the front panel)
• Firmware version
• Serial number (indicated at the bottom section on the rear panel)
p. 7-17
This product information can also be obtained using the *IDN? remote control
command.
1.2 Product Overview
The PAT is a low-noise, highly efficient Constant Voltage (CV)/Constant Current
(CC) automatic crossover power supply that employs a software switching system.
The input power mode is selectable for the three-phase input mode (200 V system) or
single-phase input mode (200 V system).
Capable to expand the system up to a maximum output of 20 kW (in the three-phase
input mode) or 15 kW (in the single-phase input mode) by the master-slave parallel
operation.
The communication function (RS232C) for remote control also comes standard with
the product.
Features
●
Selectable inp u t po w er for the three-phase inp u t mode (200 V system) or
single-phase inp u t mode (200 V system)
Possible to operate in the single-phase input mode (200 V system). The input
power mode can be switched from “three-phase input to single-phase input” or
“single-phase input to three-phase input” by the CONFIG setting. (In the single-
phase input mode, output current is limited to 75 % of the rating of three-phase
input mode.)
●
Red u ction of harmonic c u rrent and po w er transmission loss
The power-factor improvement circuit reduces the effects of harmonic currents
on the input power line. It also suppresses the peak current and reduces the
power transmission loss.
See
See