Kikusui PAT160-25T, Operation Manual

Page: 213 / 218

PAT-T 4kW
A-33
Appx
No output is delivered.
Unable to set the output voltage or output current.
Symptom Check Items Remedy
N o o u tp u t is confirmed
even w hen the OUTPUT
s w itch is t u rned on.
Is the o u tp u t voltage set to 0 V,
and the o u tp u t c u rrent set to 0 A?
T u rn the knobs to set the o u tp u t
voltage and o u tp u t c u rrent to the
req u ired val u es.
4- 8
Are yo u performing
o u tp u t on/off control
u sing an external
contact?
Yes T u rn the o u tp u t on u sing the
external contact.
5-17
N o Set the external control logic
setting of the o
u tp u t on/off to “t u rn
the o u tp u t on w ith a high signal”
(CF22: H).
4-19
See
Symptom Check Items Remedy
Unable to set the o u tp u t
voltage.
Are yo u trying to set a voltage
higher than the OVP trip point?
Change the OVP trip point or
disable the voltage limit setting
(CF29: oFF).
4-20
Unable to set the o u tp u t
c u rrent.
Are yo u trying to set a c u rrent
higher than the OCP trip point?
Change the OCP trip point or
disable the c
u rrent setting limit
(CF30: oFF)
4-20
Unable to set the o u tp u t
c u rrent to the rated val u e.
Is the prod u ct u sed in the single-
phase inp u t mode?
When the phase inp u t mode is set
to the single-phase inp u t mode,
the o u tp u t c u rrent is limited to 75
% of the rated val u e of the three-
phase inp u t mode.
4- 8
See