Kikusui PAT160-25T, Operation Manual

Page: 19 / 218

PAT-T 4kW
1-3
1
General Descri
pt
io
n
●
Po w er Factor Correction circ u it is eq u ipped
• Reducing the cost of operation
Because of the reactive power is reduced, the power can be used without wasting
of power.
• Downsized input distribution device
The input distribution device (breaker) can be downsized, because the built-in
power-factor correction circuit reduces the required input current.
• Reducing the transmission loss and harmonic current
The effect of harmonic current on the input power is reduced. And the
transmission loss can be reduced by limiting the peak current of the input power
line.
●
Master-Slave parallel operation
Up to five power supplies can be connected in parallel to expand the output
power to 20 kW (in the three-phase input mode) or 15 kW (in the single-phase
input mode) by the master-slave parallel operation.
●
O u tp u t limit f u nction
You can set the upper limit of current and voltage that is applied when setting the
output.
This function is used to prevent setting inappropriate value by mistake.
●
Remote interface
Equipped with RS232C as standard. You can select the GPIB, USB or LAN
interface as a factory option.
The remote interface complies with IEEE 488.2 std 1992 and SCPI Specification
1999.0.
●
High efficiency and lo w noise
High power conversion efficiency has reduced the rise in the internal temperature
and has contributed to the product’s compact and light design.
●
Preset memory f u nction of settings
Up to three output setting presets (combination of current and voltage) can be
saved.
You can simply select a preset to set the output without having to set the voltage
and current every time you use the PAT.
●
O u tp u t on/off delay f u nction
You can set a delay until the output is actually turned on or off after turning the
OUTPUT switch on or off.
For example, this feature is useful if you want to turn the output on/off by setting
a time offset according to the load characteristics.