Kikusui PAT160-25T, Operation Manual

Page: 58 / 218

4-16
PAT-T 4kW
Setup and view procedure of CONFIG parameters
CF01, CF02, CF50, CF52, CF53 and CF57 to CF61 are parameters only for viewing
the status. You cannot set them.
CF50 to CF61 appear only when the option board is installed. The display of the
setting varies depending on the interface option.
Fig.4-1 8 CO N FIG parameter display example
1
Press the CO N FIG key.
The key LED illuminates. The ammeter displays the parameter number, and the
voltmeter displays the present setting.
2
T u rn the CURRE N T knob to select the parameter n u mber.
3
T u rn the VOLTAGE knob to change the setting.
If you select a new setting, it blinks.
When the setting is blinking, the new setting is not entered until you press a key. If you
do not want to change the setting, turn the VOLTAGE knob and select the setting that
illuminates (not blinking) to return to the original setting.
You cannot set CF20, CF21, CF22, CF24, CF26, CF29, CF30 and CF31 when the
output is on. The present setting is displayed, but it cannot be changed even if you turn
the VOLTAGE knob.
4
To set or display other parameters, repeat step 2 and step 3 .
To exit from the CO N FIG settings, proceed to step 5 .
5
Press any of the key from SET, OVP•OCP, CO N FIG key or OUTPUT
s w itch. If it is set to the slave u nit, press CO N FIG key.
It will exit from the CONFIG setting to reflect the setting conditions.
Even when the POWER switch is turned off, the setting description will be reflected.
Setting Display
Parameter num b er
CF (CONFIG) + a 2-digit num b er
EXT EXT
RMT
LOCK
PRESET A B C
A V
OUTPUT
ALARM