PAT-T 4KW
7-27
7
Remot
e
Cont
ro
l
7.12
Other System Configuration
Sets the phase input mode (Three-phase input/Single-phase input
mode)
SYST:CONF:SPH
Sets the phase input mode (Three-phase input/Single-phase input mode)
Command
SYSTem:CONFigure:SPHase {ON|OFF|1|0}
SYSTem:CONFigure:SPHase?
Parameter
Val
u
e:
ON(1)
Select the Single-phase input mode
OFF(0)
Select the Three-phase input mode (default)
Response
Returns the setting status of phase input mode (Single-phase input/Three-phase
input mode) in the NR1 form in response to SYST:CONF:SPH?
Controlling the output on/off using an external contact
OUTP:EXT
Sets the logic used to control the output on/off using an external contact (J1
connector). This cannot be set when the output is on.
Command
OUTPut:EXTernal {NORMal|INVerted}
OUTPut:EXTernal?
Parameter
Val
u
e:
NORMal
Turn the output on with a high signal (default)
INVerted
Turn the output on with a low signal
For the setting that is applied when *RST is sent, see Table A-16.
Response
Returns the external control logic setting of the output on/off as character data in
response to OUTP:EXT?.
Summary of Contents for PAT160-25T
