Keysight Technologies N6705C, Operating And Service Manual

Page: 140 / 476

Symbol/Field Description
6 Marker 1/Marker 2 Moves the measurement markers right or left. Press Scope View to display the markers. Markers
are displayed on the selected trace. Values at the bottom of the display are referenced to the
intersection of the markers. If a marker is out of view, an arrow indicates the direction of the marker
.
Push the Marker 1 or Marker 2 knobs to reset the markers. When pushed, the following menu
appears.
Push the Enter key to Reset the marker. Push Enter again to undo the reset action. Scroll down
and select Marker options to access the Scope Marker Properties window. Scroll down and select
Jump to peak to move the marker to the peak measurement point of the trace.
Scope Properties
There are no remote interface commands that correspond directly to the front panel
Scope functions. Refer to
Digitizing Measurements for information on programming
digitized measurements from the remote interface.
With the Scope View displayed, press the Properties key to access the Scope Properties window.
Display Trace lets you select which traces to display for the output. If no box is checked, no traces will
be displayed for that output. Voltage, current, and power traces can be displayed simultaneously only
on Models N676xA and N678xA SMU, as these models have simultaneous voltage and current
measurement capability (see
Model Differences ). All other power modules can display either voltage
or current traces, but not simultaneously.
Source dropdown lets you select a trigger source. This trigger source will trigger the scope
measurements on all output channels. Depending upon the selected trigger source, you can trigger
the scope as follows:
4 Using the Measurement Functions
140 Keysight N6705C Operating and Service Guide