Keysight Technologies N6705C, Operating And Service Manual

Page: 443 / 476

l
Use a conductive wrist strap to reduce static charge accumulation.
l
Minimize handling.
l
Keep replacement parts in original static-free packaging.
l
Remove all plastic, foam, vinyl, paper, and other static-generating materials from the work area.
Disassembly Tools
Tool Use
N6705CT10 Torx driver All Disassemblies
T20 Torx driver Removing Top Chassis, AC Module, Bulk Supply and Calibration
7/32 in. nut driver Removing Ground Nut
1/4 in. nut driver Removing Binding Post Assembly
11/32 in. nut driver Removing Bulk Supply Cable
5/8 in. nut driver Removing Trigger Assembly
Flat Blade driver Replacing Battery and Calibration
Diagonal cutters Removing top and bottom backplanes
Philips pozidrive Removing side cover without handle
Disassembly Procedures
Removing/Installing Flat Flexible Cables (FFC)
l
Note the position of the conductive side of the cable for re-installation. (The blue tab is on the non-
conductive side.)
l
To remove the FFC cable, gently lift up on the tabs located on the short ends of the plastic con-
nector until the cable is released. Remove the cable.
l
To install the FFC cable, insert the cable into the slot in the connector. Using a small screwdriver
or your fingers, apply gentle, even pressure to the tabs until the connector clicks and locks the
cable into place. After installation, check the cable to ensure the cable is straight and securely
aligned within the connector
Keysight N6705C Operating and Service Guide 443
9 Service and Maintenance