Keysight Technologies 86120B, User Manual

Page: 128 / 273

126
Programming
Lists of Commands
:DISPlay:MARKer:MAXimum:NEXT Moves the marker to the signal with the closest power
level just below the power level of the signal at the current
marker position. I
:DISPlay:MARKer:MAXimum:PREVious Moves the marker to the signal with the closest power
level just above the power level of the signal at the current
marker position. I
:DISPlay:MARKer:MAXimum:RIGHt Moves marker to the next higher wavelength or
frequency. I
:DISPlay[:WINDow]:GRAPhics:STATe Turns the instrument display of the power bars on and off. S
HCOPy Subsystem
:HCOPy:IMMediate Starts a printout. S
SENSe Subsystem
:SENSe:CORRection:DEVice Configures wavelength measurements for narrowband or
broadband devices. I
:SENSe:CORRection:ELEVation Sets the elevation value used by the instrument to
compensate for air dispersion. I
:SENSe:CORRection:OFFSet:MAGNitude Sets the power offset value used by the instrument. S
:SENSe:CORRection:MEDium Sets the instrument to return the wavelength reading in a
vacuum when the parameter is on. Parameters are VAC
and AIR. I
:SENSe:DATA? Queries the time domain samples of the input signal. I
STATus Subsystem
:STATus:{OPERation | QUEStionable}:CON
Dition? Returns the value for the condition register for the node. S
:STATus:{OPERation | QUEStionable}:EVE
Nt? Returns the value of the event register for the node. S
:STATus:{OPERation | QUEStionable}:ENA
Ble Sets the enable register. S
:STATus:{OPERation | QUEStionable}:PTR
ansition Sets the positive transition filter register. S
:STATus:{OPERation | QUEStionable}:NTR
ansition Sets the negative transition filter register. S
:STATus:PRESet Presets the enable registers for all status nodes. S
SYSTem Subsystem
:SYSTem:ERRor? Queries an error from the error queue. S
Table 4-11. Programming Commands (4 of 5)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.