Keysight Technologies 86120B, User Manual

Page: 127 / 273

125
Programming
Lists of Commands
:CALCulate3:DELTa:REFerence:POWer? Queries the power level of the reference signal. I
:CALCulate3:DELTa:REFerence[:WAVelen
gth] Selects the signal to be used as the reference for the
DELTa calculations. I
:CALCulate3:DELTa:REFerence:WNUMber Selects the signal to be used as the reference for the
DELTa calculations. I
:CALCulate3:DELTa:WAVelength[:STATe] Turns the delta wavelength measurement mode on and
off. I
:CALCulate3:DELTa:WPOWer[:STATe] Turns the delta wavelength and power measurement mode
on and off. I
:CALCulate3:DRIFt:DIFFerence[:STATe] Sets the drift calculation to subtract the minimum values
measured from the maximum values measured. I
:CALCulate3:DRIFt:MAXimum[:STATe] Sets the drift calculation to return the maximum power
(frequency) values measured. I
:CALCulate3:DRIFt:MINimum[:STATe] Sets the drift calculation to return the minimum power
(frequency) values measured. I
:CALCulate3:DRIFt:PRESet Turns off all the drift states for DIFFerence, MAXimum,
MINimum, and REFerence. I
:CALCulate3:DRIFt:REFerence:RESet Places the current list of signals into the reference list. I
:CALCulate3:DRIFt:REFerence[:STATe] Turns the drift state on and off so that CALC3:DATA?
will return the reference signal list. I
:CALCulate3:DRIFt[:STATe] Turns the drift measurement calculation on and off. I
:CALCulate3:POINts? Queries the number of points in the data set. I
CALCulate3:PRESet Turns off any CALCulate3 calculation that is on. I
:CALCulate3:SNR:AUTO Selects the internal or externally entered frequency value
for the noise measurement reference in the SNR
calculation. I
:CALCulate3:SNR:REFerence:FREQuency Sets the frequency used for the noise measurement
reference in the SNR calculation. I
:CALCulate3:SNR:REFerence[:WAVelength
] Sets the wavelength used for the noise measurement
reference in the SNR calculation. I
:CALCulate3:SNR:REFerence:WNUMber Sets the wave number used for the noise measurement
reference in the SNR calculation. I
:CALCulate3:SNR[:STATe] Turns the SNR calculation on and off. I
DISPlay Subsystem
:DISPlay:MARKer:MAXimum Sets the marker to the signal with the largest power. I
:DISPlay:MARKer:MAXimum:LEFT Moves marker to signal with the next lower wavelength or
frequency. I
Table 4-11. Programming Commands (3 of 5)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.