Johnson & Johnson Surgical Vision Veritas, Operator'S Manual

Page: 217 / 270

Error Messages, Troubleshooting, and Diagnostics
Z370584 Rev. D Status, Warning, and Error Messages
10-19
3. If the error does not clear, select End Case .
4. Select Shutdown .
5. Select Yes and wait for the system to power off.
6. Start up the system.
7. Retune the handpiece.
8. If the error still does not clear, replace the handpiece with a new handpiece and tune the
handpiece.
9. If the error still does not clear or if the error continues to occur, document the error
message and contact JJSV for technical service.
206 Phaco controller ADC error.
Probable cause: Phaco controller ADC problem.
Corrective action:
1. Select End Case .
2. Select Shutdown .
3. Select Yes and wait for the system to power off.
4. Start up the system.
5. If the error still does not clear or if the error continues to occur, document the error
message and contact JJSV for technical service.
207 Handpiece not supported.
Probable cause:
• Incompatible handpiece.
Corrective action:
1. Change to a different handpiece.
2. Tune the handpiece and continue surgery.
3. If the error still does not clear or if the error continues to occur, document the error
message and contact JJSV for technical service.
208 Handpiece error.
Probable cause:
• Hardware failure.
• The handpiece is shorting out.
Corrective action:
1. Check the handpiece connections
2. Retune the handpiece.
3. If the error does not clear, select End Case .