Johnson & Johnson Surgical Vision Veritas, Operator'S Manual

Page: 212 / 270

Status, Warning, and Error Messages Z370584 Rev. D
10-14
Error Messages, Troubleshooting, and Diagnostics
2. Select Next Case .
3. Replace the Fluidics Tubing pack.
4. If the error does not clear or if the error continues to occur, document the error message
and contact JJSV for technical service.
130 Fluidics encoder error.
Probable cause:
• There is a Fluidics Tubing pack loading problem.
• Encoder, decoder or stepper driver circuit failed.
Corrective action:
1. Select End Case .
2. Select New Case .
3. If the error does not clear select End Case .
4. Select Shutdown .
5. Select Yes and wait for the system to power off.
6. Start up the system.
7. Remove the Fluidics Tubing pack.
8. Reinstall the Fluidics Tubing pack.
9. Install a new Fluidics Tubing pack.
10. If the error does not clear or if the error continues to occur, document the error message
and contact JJSV for technical service.
131 Fluidics mode error.
Probable cause:
• Instrument Host malfunction
• Bad SSC Board
• Bad Foot pedal
Corrective action:
1. Select End Case .
2. Select Shutdown .
3. Select Yes and wait for the system to power off.
4. Start up the system.
5. Disconnect the foot pedal from the system.
6. Connect the foot pedal to the system.
7. Press and release the foot pedal at least three times.
8. Run the Self Test .
9. Replace the foot pedal.