JBT FoodTech Frigoscandia GYRoCOMPACT M7, Installation Manual

Page: 251 / 288

167
1000-06-01GB-10-11
CORRECTIVE MAINTENANCE
FRIGoBELT M Conveyor
Note!
Make sure that one inner and one outer link and
two rods are available before cutting the con-
veyor belt. The cutted links and rods can not be
used again.
Cutting the conveyor belt
1. Uncover the rod (A) to be cut by pushing the
mesh (B) against the opposite side of the
conveyor belt.
2. Cut both rods welded to the side links (D).
It is only needed to cut the rods on one side
of the conveyor belt.
3. Pull the side links and rods out and remove
the mesh.
Note!
Make sure there are no cut marks on the side
links.
Splicing the conveyor belt
4. Pull the two conveyor belt ends together.
5. Join the conveyor belt ends using two rods
and one piece of mesh.
6. Place the side links in position.
Note!
• Make sure the pulling links (H) are in posi -
tion on the rods.
• Make sure the mesh is correctly aligned.
• Make sure the rods are centred between the
link feet (C ).
• Make sure that the end of the rod with the
washer is placed at the outer side of the
conveyor belt.
• Place the side link in same position as the
rest of the links in the conveyor belt.
A
B
B H
A D
D
A
H
B
C
A
B
Mesh in wrong position Mesh in right position