JBT FoodTech Frigoscandia GYRoCOMPACT M7, Installation Manual

Page: 120 / 288

10
INSTALLATION
1000-07-01GB-26-06
Example GCM10 FDM
Show the magnet to the switch at the first stand after the drive
motor, at the first and second tier. The revolution time is 66 sec-
onds. The first stand is positioned at 56.25 degrees, the transfer
takes in theory place at 40° degrees.
66 seconds / revolution =360/66=5.45 degrees/second. 56.25-
40=16.25 degrees. 16.25/5.45=2.98. The transfer is taking
place 3 seconds before your first signal from the proximity
switch at the first tier. The proximity switch can also be used to
show other belt force sensors position. For example, when the
sensor approches the cheese cutter, or the position of the sen-
sor at the outfeed rail, just before the belt stops.
Stop logging data
1. Stop the belt when the logger is in the correct end posi-
tion. Note that the belt will travel a bit before it comes to a
complete stop. If the belt runs too far there is a risk that the
outfeed release plate damages the load cell and logger.
2. Remove the load cell from the belt and let it rest for about
10 seconds in order to let the logger read the values when
the load cell is unloaded.
3. Press the Measure STOP button on the logger to stop log-
ging more measurements. Remove the logger and load cell
from the belt.