JAC A-CLASS, Manual

Page: 87 / 176

4. Place the jack
Place the jack base on the solid and
level ground and set the jack to the
position shown in the figure.
5. Jack the vehicle up
Wheel nut
Spanner
Spanner extension bar
Insert the spanner extension bar in
the nut spanner and install the
spanner extension bar in the jack, as
shown in the figure. To jack the
vehicle up, rotate the wheel nut
spanner clockwise. Before jacking
the wheel, check and confirm the
jack position again to avoid the jack
sliding. Where the jack is placed on
the floppy ground or the sands, you
should place an appropriate slab,
brick, level stone or other similar
3. Loosen the wheel nuts
Unscrew the wheel nuts slightly
before
jacking the wheel. To
unscrew the nuts, rotate them
counterclockwise. The sleeve must
match the nut completely to prevent
sleeve sliding. To fully exert the
spanner
function, the spanner
position must be in the position
shown in the figure. Depress the
spanner with stable force while
holding the spanner handle end.
However, do not remove the nuts at
this moment, just keep them loose.
87