JAC A-CLASS, Manual

Page: 29 / 176

Replacement of Battery
Tips
◎ Take care to avoid contact with
the circuit board when replacing the
battery. The static electricity transm
-itted to the circuit board from your
body will damage the emitter.
◎ Do not touch the two surfaces of
Note
To keep the proper operating
state of emitter, please observe
the following rules
◇ Do not drop the emitter on the
ground.
◇ Do not place heavy goods on
the emitter.
◇ Do not have the emitter
contact water or subject it to
direct sunshine. Wipe the emit
-ter dry with soft cloth if it's
wet.
29
In case the LED is not on or the
emitter can work only when near the
vehicle, the battery must be replaced
immediately.
Replace the battery of remote
control door lock emitter in the
following procedures.
1
） Remove the front cover plate of
remote control key and take the
emitter out.
2
） Open the emitter cap carefully,
take the old battery out and install
the new battery of the same model,
making sure to keep the positive
pole of battery facing upward.
3 ） Fit the emitter cap back and
ensure the cap is tight and water
proof.
4
） Put the emitter in the remote
control key and fit the cover plate.
5
） Test the operation of emitter.
① Press the two button s of emitter
at the same time for about 10s, the
LED indicator lamp will twinkle
swiftly and then go off.
② Press the locking and unlocking
button three times continuously and
respectively, exceeding 1.5s for each
time. Release the button if the LED
indicator lamp goes off and then it
will continue to twinkle.
battery with bare fingers. Otherwise,
the battery life will be shortened.
◎ The used battery is harmful to the
environment.
◎ Observe the local recycling laws
and regulations on disposal of waste
batteries.
◎ Do not throw the batteries away
together with household garbage.