JAC A-CLASS, Manual

Page: 90 / 176

90
Place the spanner to the position
shown in the figure, ensure the
sleeve completely match the nut and
rotate
the wheel nut spanner
clockwise to tighten the nuts. Never
stand on the spanner handle or use
extension pipe for the spanner.
Tighten all the wheel nuts and check
the tightening conditions of the nuts
again. To guarantee the proper
torque after replacing the wheel,
have the technician tighten the
wheel nuts as soon as possible.
Notices after tyre replacement
Where tyre pressure gauge is
available, unscrew the valve cap and
check the air pressure. If the air
pressure is lower than the specified
value, drive your vehicle to the
nearby
privileged maintenance
station at a low speed and inflate the
tyre to the specified pressure. If the
tyre pressure is too high, adjust it to
the specified value. Reinstall the
valve cap after checking or adjusting
the air pressure. If the valve cap is
not installed, the tyre may present
leak. Where the valve cap loses,
purchase a new one and install it
immediately.
After wheel replacement, tighten the
burst tyre and place the jack and
tools to their storage position.
Start the engine through
jumper cable
Note
Where the vehicle cannot be
started due to battery electricity
loss, do not attempt to start the
vehicle
through pushing or
towing.
Otherwise, the catalytic conve
-rter and automatic transmis
-sion may be damaged, even
causing personal injury.
You can transfer the battery power
of another vehicle to the vehicle
whose battery has discharged to
start the vehicle.