JAC A-CLASS, Manual

Page: 110 / 176

Add coolant
If the liquid level is below the lower
limit (L) sign, it may add suitable
coolant mixture into the expansion
kettle, but fill after the engine is
cooled only.
If the coolant is splashed onto
hot
engine parts and
components, you may be burnt.
The coolant contains glycol. If
temperature of engine parts and
components is high enough,
glycol will burn. Therefore, do
not splash coolant onto the hot
engine.
When closing the
expansion kettle cover again,
please confirm the cover is
screwed tight.
Notes
Notes
It is very dangerous to add clean
water into the cooling system,
because boiling point of clean
water or alcohol is lower than
that of normal coolant mixture.
And coolant alarm system of the
car is set according to normal
coolant mixture. Use of water or
other unsuitable liquid mixture
may result in engine overheat,
but the alarm system will not
sound an overheat alarm. The
engine fires, which may burn
you or others. Make sure to use
liquid mixture of clean drinking
water and suitable coolant at the
ratio of 43/57.
In cold days, water may cause
freezing breakage of the engine,
How to add coolant into the
coolant expansion kettle
radiator and other parts and
components. Therefore, please
use the recommended coolant
and correct coolant mixture.
You may take off coolant expansion
kettle
cover after the cooling
system, including coolant expansion
kettle cover and radiator hose is
cooled.
Add suitable liquid mixture into the
coolant expansion kettle until hitting
the upper limit sign of the expansion
kettle. Wait for 5 minutes, and then
check whether the liquid level is
below the upper limit sign. If yes,
continuously add some coolant to
increase the liquid level to the upper
limit sign. Repeat such step until the
110