JAC A-CLASS, Manual

Page: 88 / 176

Note
Ensure there is no foreign body
(such as earth, tar oil, sand gravel
etc.) in the hub or wheel, as the
foreign body may prevent the
wheel fixing to the hub. Where
there are such substances, clear
them away. In case the assembly
surfaces of wheel and hub cannot
have proper contact, thus the
6. Replace the wheel
Unscrew the wheel locking nuts and
remove them by hand. Move the
wheel slightly to slide it out of the
studs and then place it on the
ground to prevent it rolling. Lift the
spare tyre, align it with the stud and
slide it in. If this operation is too
difficult, push the wheel in slightly
and align the holes in the upper
section of the wheel with the stud.
And then shake the wheel front and
back until the wheel slides in.
88
Note
Never enter the vehicle bottom
while jacking the vehicle up
since this will be extremely
dangerous.
Severe personal
injury may occur in the event of
vehicle falling. No passenger
should stay in the vehicle while
the vehicle is being jacked up.
object under the jack to prevent jack
sinkage.
Fully jack the vehicle up to install the
spare tyre. Installation of spare tyre
requires greater ground clearance
than that required by removing the
burst tyre.