JAC A-CLASS, Manual

Page: 78 / 176

Note
ABS neither changes the time
required by brake engagement
nor shortens the braking length
absolutely.
Please maintain
sufficient braking length even if
your vehicle is equipped with
ABS.
Note
When the vehicle passes through
water or is washed, or the brake
is excessively applied on long
and steep slope, the brake will
lose braking capacity temporarily.
This might be caused by brake
components wetting or overhe
-ating.
Anti-lock braking system is an
advanced electronic brake system
which helps to prevent vehicle
sliding and out-of-control. This
system enables you to steer clear of
obstacle upon hard braking and
provides maximum stop ability on
slipping road surface.
When
the ignition switch is
switched on by half, the ABS
warning lamp will be on for about 3s.
If the ABS warning lamp is not off or
it's on during driving, it indicates the
ABS is at fault. Please consult the
Engaged
After Service Center
designated by JAC immediately.
Refer to ABS warning lamp. The
ABS system will monitor each wheel
speed during braking. Where any
wheel tends to be blocked, the
computer will control the brakes of
driving and do not apply the brake
continuously.
For details, refer to Engine braking
below in this chapter.
Anti-lock braking system (ABS)
the two front wheels and rear
wheels respectively. When the ABS
is working, the brake pedal will
present slight vibration accompanied
with noise generally.
78