JAC A-CLASS, Manual

Page: 28 / 176

Operation of Remote Control Door
Lock System (if equipped)
You may have noted that the
effective range of emitter may be
smaller sometimes. In fact, this is
normal for any remote control door
lock system. In case the emitter
does not work, or it works only
when you are near the vehicle,
please try the following procedures:
◇ Check the distance. Maybe you
are too far away from the vehicle. In
rain or snow days, you should be
near the vehicle when using the
remote control.
◇ Check the vehicle position to see
whether other vehicles or objects
block the signal; walk leftwards or
Remote control door lock system
The door can be locked or unlocked
through the remote control door lock
system
Locking Pressing the
button on
the key can lock all the doors. If all
the doors are locked, the hazard
warning light will blink once to
indicate the vehicle has been locked
and the anti-theft system will
activate.
◇ Unlocking Pressing the button
Tips
◎ The button of remote control door
lock emitter will do work and the
anti-theft system will not activate if
the ignition key is not pulled out.
◎ If one of doors, rear hatch or
engine bonnet is not fully closed, the
warning lamp will not flash during
locking and the anti-theft alarm
system is not enabled. Please check
whether four doors and two bonnets
are fully closed.
28
on the key can open all the door
locks. The hazard warning light will
blink twice to indicate the vehicle
has been unlocked and the anti
-theft system has been released. rightwards, raise the emitter a little
and try again.
Check whether the battery should be
replaced. Refer to the Replace
-ment of Battery in the Operation of
Remote Control Door Lock System
in this chapter.
If the problem still exists, please
contact the JAC sale service center
for repair.