REL0.2
Page 37 of 88
Zynq Ult MPSoC SBC Hardware User Guide
iWave Systems Technologies Pvt. Ltd.
2.7.4
3G/12G SDI IN (Optional)
The Zynq Ult SBC supports one 3G/12G SDI Video IN interface through HD BNC connector (J20). The Video
input signals from HD BNC Connector is directly connected to Adaptive Cable Equalizer chip and then connected to PL
Bank224 Channel3 GTH receiver of Zynq Ult MPSoC.
The Zynq Ult MPSoC SBC supports Video Input Lock status LED (D17) for presence and absence of the Video
Input signal on HD BNC connector (J20). This LED will glow when the Video Input signal is detected on HD BNC
connector (J20). Also PS I2C0 is connected to Adaptive Cable Equalizer chip for control and configuration with I2C
address 0x2D.
Important Note: In Zynq Ult MPSoC SBC, GTH Transceiver Channel3 is shared with SFP+ and SDI In & Out. So
either SFP+ or SDI IN & Out only can be supported. By default SFP+ is supported in SBC. Contact iWave to support SDI
IN & Out.
2.7.5
3G/12G SDI Output (Optional)
The Zynq Ult MPSoC SBC supports one 3G/12G SDI Video OUT interface through HD BNC connector (J19). Zynq
Ult MPSoC’s PL Bank
224 Channel3 GTH transmitter from
Zynq Ult MPSoC’s
is directly connected to
Cable Driver chip and then connected to HD BNC Connector (J19) for Video out.
The Zynq Ult MPSoC SBC supports Video Output Lock status LED (D16). This LED will glow when the video
signal from MPSoC GTH transmitter is detected on Cable Driver chip. Also PS I2C0 is connected to Cable Driver chip for
control and configuration with I2C address 0x30.
Important Note: In Zynq Ult MPSoC SBC, GTH Transceiver Channel3 is shared with SFP+ and SDI In & Out. So
either SFP+ or SDI IN & Out only can be supported. By default SFP+ is supported in SBC. Contact iWave to support SDI
IN & Out.
