REL0.2
Page 15 of 88
Zynq Ult MPSoC SBC Hardware User Guide
iWave Systems Technologies Pvt. Ltd.
General Specification
•
Power Supply
:
12V, 5A Power Input Jack
•
Form Factor
:
72mm x 100mm
1
In Zynq Ult MPSoC SBC, SD1 signals from MPSoC is shared with WLAN module and MicroSD connector. So
either WLAN or Micro SD connector can be supported. By default WLAN module is supported in SBC. Contact iWave to
support Micro SD connector.
2
In Zynq Ult MPSoC SBC, UART1 signals from MPSoC is shared with Bluetooth and Board to Board connector1
So either Bluetooth or Board to Board connector1 UART can be supported. By default UART1 is supported in Bluetooth
in SBC. Contact iWave to support UART1 on Board to Board Connector1.
³ Important Note: Since PL-GTH Transceivers are not supported in ZU3 & ZU2 Zynq UltMPSoC, these features
from PL-GTH are not supported in ZU3 & ZU2 Zynq UltMPSoC based SBC.
4
In Zynq Ult MPSoC SBC, GTH Transceiver Channel3 is shared with SFP+ and SDI In & Out. So either SFP+ or SDI
IN & Out only can be supported. By default SFP+ is supported in SBC. Contact iWave to support SDI IN & Out.
⁵
In ZCU2 & ZCU3 MPSoC devices, the PL Bank 43, 44, 45 & 46 is called as 44, 24, 25 & 26 respectively. Only the Bank
Numbering is different and all other functionalities remain same.
