INTEC GmbH
22/12/2016
Lift controller MLC 8000
Operating manual V2.0
54/196
1. Menu level
2. Menu level
3. Menu level
4. Menu level
Description
Settings
Module
Used module on HSE: Analog modem or Ethernet module
Dial delay[s]
Waiting time between 2 dial attemps
Dial attemps
Number of dial attemps
Taking calls
Number of rings till connection
Timeout[s]
Time after which the controller terminates the connection if no
messages are received.
Block size
Max. length of a message
Modem module
Parameter for onboard analog modem module
Dialtone det.
Dial tone detection active (see ATX command)
Busy detect.
Busy detection active yes / no (see ATX command)
Line dialing
Number for line dialing (if using on a PBX)
Add.Init
Here additional ATX commands for initializing the onboard module
may be defined (if necessary).
Ethernet module
IP
IP address of Ethernet module (or domain name; see below)
Local Port
Local port of Ethernet module
DNS
Definition of a Domain Name Server (IP adress).
Necessary if a domain name is used instead of an IP adress.
Gateway
Definition of a gateway address (IP address).
Necessary if the target address (PC) is located behind a router.
Subnet
Definition of a subnet mask (address area inside local network)
Blocktime[ms]
Waiting time until start transmission of a message over network.
Blocksize
Max. block size. If max. block size is reached the message will be
transmittedwithout delay (see above).
Add.Init
Here additional ATX commands for initializing the onboard module
may be defined (if necessary).
SMS Alarm
in case of failure , an SMS can be sent to up to 3 different phone
numbers
SMS Number 1
Parameters for 1st SMS number
Send SMS
Activate 1st SMS number
Prov.
Telephone number of SMS provider
