INTEC GmbH
22/12/2016
Lift controller MLC 8000
Operating manual V2.0
69/196
1. Menu level
2. Menu level
3. Menu level
4. Menu level
Description
Brake 1
Switch off brake 1
Brake 2
Switch off brake 2
Brake 3
Switch off brake 3
Brake/valv.check
Testing the brake or valve supervisio contacts
On in standstill
Testing the supervision contact while lift is standstill
Brake 1
Selecting a contact for testing
Brake 2
Up valve
...
Off on trip
T Testing the supervision contact while lift is moving
...
On by stop
Testing the supervision contact at trip end
...
Runn. contactor
Test of mains contactors supervising.
It can be defined, which relay of the HSE should remain on after trip
end.
Open door safety
Test of safety circuit for moving with open doors
Uncontr.movement
Test UCM (uncontrolled movement)
Upward dir.
Test in upward direction
Downward dir.
Test in downward direction
Battery check
Example:
Voltage 12850 mV
Manual start of a battery test.
Note: The battery test is also performed automatically at the set time
interval (default is 24 hours).
Up to software version 1.38a this menu item is located directly in the
main menu.
Reset HSE
Perform a software reset of the HSE.
Teach in trip
Calibration of the lift during commissioning.
Depending on the type of the positioning system (incremental or
absolute encoder) different sub menu items appear here.
Note: If conventional positioning with switches only is used a teach-in
trip is not required.
Sub menus if Positioning system with incremental encoder
