INTEC GmbH
22/12/2016
Lift controller MLC 8000
Operating manual V2.0
4
CAN-
CAN-Bus – Low signal
XP2
1
0(24V)
0V Power supply for inputs / outputs
2
3
4
5
6
7
8
9
D1
D2
D3
D4
D5
D6
D7
D8
8 inputs / outputs E1-E8 and A1-A8, low active, free programmable.
Connector XP2 is in parallel to XP3 (same inputs/outputs)
10
+24V
+24V Power supply for inputs / outputs
XP3
1
2
3
4
5
6
7
8
D1
D2
D3
D4
D5
D6
D7
D8
8 inputs / outputs E1-E8 and A1-A8, low active, free programmable.
Connector XP3 is in parallel to XP2 (same inputs/outputs)
9
0(24V)
0V Power supply for inputs / outputs
10
+24V
+24V Power supply for inputs / outputs
XP4
Connector for Software download
XJ1
Jumper for setting of node ID:
Jumper set to the top (PCB edge): Normal operation
Jumper set to the bottom: Initialization mode (setting of node ID)
XJ2
Jumper for CAN bus terminator
→ Jumper must be set if PMA is located at the end of the CAN bus cable.
XJ3
Jumper for orientation of PMA: horizontal (Jumper not set) or vertical (Jumper set)
LED
LED “Software is running”
Technical specifications:
Temperature range:
0
°
C to +60
°
C
Current in idle mode:
ca. 35mA @ 25
°
C
Max. input current D1-8:
10mA @ 25
°
C / Input
Max. output current D1-8 (PMA.1):
500mA @ 25
°
C / Output
Max. output current D1-8 (PMA.2):
350mA @ 25
°
C / Output
Mechanical dimensions:
Length:
69mm
Width:
62mm
Height:
ca. 30mm (without connector)
Display module: 3 Modules a 39*23mm
