IBM System x3950, Problem Determination And Service Manual

Page: 145 / 190

5. Replace the memory card (see “Removing and replacing a memory card” on
page 126).
6. Install the top cover (see “Top cover and bezel” on page 131).
7. Slide the server into the rack.
8. Connect the cables and power cords (see “Connecting the cables” on page 120
for cabling instructions).
9. If you turned off the server to replace the DIMM, turn on all attached devices
and the server.
Remote Supervisor Adapter II SlimLine
The Remote Supervisor Adapter II SlimLine must be installed in its dedicated
connector on the I/O board.
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps:
I/O board
Remote Supervisor Adapter II SlimLine
Remote Supervisor Adapter II SlimLine connector
Rear standoff
Front standoff
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 117.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Top cover and bezel” on page 131).
4. Release the retention latch on the rear standoff and pull the adapter from the
I/O board.
5. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
To install the replacement Remote Supervisor Adapter II SlimLine, complete the
following steps:
1. Insert the rear of the adapter into the rear standoff; then, rotate the front of the
adapter into the front standoff.
2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
3. Install the top cover (see “Top cover and bezel” on page 131).
Chapter 4. Removing and replacing server components
129