IBM SAN32M1, Installation And Service Manual

Page: 284 / 626

SAN32M1 Fabric Switch Installation and Service Manual 252
28
Inspect the switch reporting the problem for indications of being
powered on, such as:
• At the front panel, an illuminated PWR or ERR indicator.
• Green LEDs illuminated on the power supplies.
• Audio emanations and airflow from fans.
Does the switch appear powered on?
YES NO
↓
Analysis for an AC power distribution or CTP card failure is
not described in this MAP. Go to
MAP 0000: Start MAP on
page 195. If this is the second time at this step, contact the
next level of support.
29
Either a switch-to-PC Internet link problem (Internet too busy or IP
address typed incorrectly) or a switch Ethernet port failure is
indicated.
a. Wait approximately five minutes, then attempt to login to the
switch again.
b. At the Netsite field (Netscape Navigator) or Address field
(Internet Explorer), type http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the IP address of the switch (obtained in
MAP 0000: Start MAP on page 195). The Username and
Password Required dialog box appears.
c. Type the user name and password (obtained in MAP 0000: Start
MAP on page 195) and click OK. If the View panel does not
display, wait another five minutes and perform this step again.
Does the SANpilot interface appear operational with the View panel
displayed?
NO YES
↓
The switch-to-SANpilot PC connection is restored and
appears operational.
30
An unrecoverable Ethernet fault (reported as event code 433) is
indicated. The event code is not reported to the Event Log or the
SANpilot event log, and must be verified through the switch
maintenance port. A maintenance terminal (desktop or notebook PC)