IBM SAN32M1, Installation And Service Manual

Page: 90 / 626

SAN32M1 Fabric Switch Installation and Service Manual 58
The following paragraphs provide instructions to unpack and inspect
one or more Ethernet hubs, and install the hubs in a desktop or
rack-mount configuration.
Unpack and inspect the Ethernet hub
Unpack and inspect the Ethernet hub(s) as follows:
1. Inspect shipping container(s) for damage caused during transit. If
a container is damaged, ensure a representative from the freight
carrier is present when the container is opened.
2. Unpack shipping container(s) and inspect each item for damage.
Ensure the packaged items correspond to the items listed on the
enclosed bill of materials.
3. If any items are damaged or missing, call the IBM Quality Hotline
toll-free in U.S. and Canada: 1-800-442-6773, or direct dial in other
locations: 770-858-8459.
Desktop installation
To install and configure up to three Ethernet hubs on a desktop:
1. Remove the backing from the four adhesive rubber pads and
apply the pads to the underside of each hub. Ensure the pads
are aligned with the scribed circles at each corner.
2. Position the first hub on a table or desktop as directed by the
customer.
3. Stack the remaining hubs on top of the first hub as shown in
Figure 11 . Ensure the adhesive rubber pads on the underside of a
hub align with the recesses on the top of the hub below.