IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 75 / 192

Table 9. Cabling tasks to enable remote access to the Remote Supervisor
Adapter (continued)
User interface to Remote
Supervisor Adapter Connection to Remote
Supervisor Adapter For the cabling procedure, see:
Text-based user interface
using a modem or a null
modem Serial (COM) port “Cabling the serial (COM)
port” on page 68
ASM Web interface using
point-to-point (PPP)
protocol
Text-based user interface
using the TELNET
protocol over PPP
Cabling the Ethernet LAN port
To attach the Ethernet cables, complete the following steps.
Attention: To avoid damage to the Ethernet connector on the Remote Supervisor
Adapter, do not plug the ASM Interconnect module into the Ethernet (RJ-45) port.
1.
Connect one end of a Category 5 Ethernet cable to the Ethernet port on the
Remote Supervisor Adapter. Connect the other end of the Ethernet cable to
your network.
2. Check the Ethernet LEDs. The location of the LEDs is shown in the following
illustration.
Installing options
67