IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 98 / 192

Removing a microprocessor
Do the following to remove a microprocessor:
Note: Do not use any tools when removing the microprocessor.
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to “Handling electrostatic discharge-sensitive devices” on page 150.
1. Review the safety precautions listed in “Safety information” on page 147.
2. Turn off the server/workstation and peripheral devices and disconnect the
power cord and all external cables; then remove the cover (see “Removing the
cover” on page 48 for details).
3. Remove the clear shield from the server/workstation and store it in a safe
place.
4.
To remove microprocessor #2:
a. Remove the clip from the heat sink by pushing forward on the back of the
clip and up on the lever. After the clip releases from the heat sink, lift it up
and off the heat sink.
Note: A thermal material is used between the heatsink and the processor.
This material, when heated and cooled, causes the heatsink to adhere
to the processor. Some force may be required to remove the heatsink.
b. Firmly grasp the heat sink and lift it off the microprocessor.
Attention:
Do not use excessive force or tools to remove the heatsink.
c. Discard the used heatsink.
d.
Lift up the release lever and remove the microprocessor from the connector.
Store the microprocessor in a static-protective bag for possible future use.
Note: If you are installing a new microprocessor, go to “Installing the
microprocessor” on page 88.
If you are not replacing the microprocessor, then you must reinstall
the terminator card. Push the release latch down to lock the
terminator card into place.
Note: It is very important to replace the clear shield.
90
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674