IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 32 / 192

CAUTION:
When replacing the battery, use only IBM Part Number 33F8354 or an equivalent
type battery recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v
Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To replace the battery:
1.
Read “Before you begin” on page 45, and follow any special handling and
installation instructions supplied with the replacement battery.
2. Turn off the server/workstation and peripheral devices and disconnect all
external cables and power cords.
3. Remove the server/workstation from the rack (see “Rack installation” on
page 46).
4. Remove the cover (see “Removing the cover” on page 48).
5. Remove the battery:
a.
Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
6.
Insert the new battery:
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
24
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674