IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 114 / 192

Because you set this priority at the host or entry point of the network, the network
devices can base forwarding decisions on priority information defined in the
packet.
Priority Packet information is available on the IBM Networking Web site at:
http://www.ibm.com/networking/support
Priority Packet prioritizes traffic based on priority filters. These are parameters you
assign to outgoing (transmit) packets. Using the Priority Filter Wizard, you can set
up predefined or custom priority filters based on a node (MAC) address, Ethernet
type, or by various properties of the protocol and port. Priority Packet provides
two different methods for prioritizing traffic: IEEE 802.1p tagging and High
Priority Queue.
IEEE 802.1p is a new IEEE standard for tagging, or adding additional bytes of
information to packets with different priority levels. Packets are tagged with 4
additional bytes, which increase the packet size and indicate a priority level. When
you send these packets out on the network, the higher priority packets are
transferred first. Priority packet tagging (also known as Traffic Class Expediting)
allows the adapter to work with other elements of the network (such as switches
and routers) to deliver priority packets first. You can assign specific priority levels
from 0 (low) to 7 (high).
You can assign values to packets based on their priority when you use the IEEE
802.1p standard for packet tagging. This method requires a network infrastructure
that supports packet tagging. The routing devices receiving and transferring these
packets on your network must support 802.1p for tagging to be effective.
After you set up the priority filter in Priority Packet, you must launch IBMSet and
select
802.1p/802.1Q Tagging on the Advanced tab.
Note: IEEE 802.1p tagging increases the size of the packets it tags. Some hubs and
switches will not recognize the larger packets and will drop them. Check
your hub or switch documentation to see if they support 802.1p. (You can
configure the switch to strip the tags from the packets and send it on to the
next destination as normal traffic.) If these devices do not support 802.1p or
if you are not sure, use High Priority Queue (HPQ) to prioritize network
traffic.
The requirements for effectively using IEEE 802.1p tagging are:
v
The other devices receiving and routing 802.1p tagged packets must support
802.1p.
v
The adapters on these devices must support 802.1p. The Ethernet controller in
all IBM 10/100 Ethernet Security Adapters and IBM 10/100 Ethernet
server/workstation Adapters support 802.1p.
v
The adapter cannot be assigned to an adapter team.
v
If you are setting up VLANs and packet tagging on the same adapter,
802.1p/802.1Q Tagging must be enabled on the IBMSet Advanced tab.
If your network infrastructure devices do not support IEEE 802.1p or you are not
sure, you can still define filters and send packets as high priority. While High
Priority Queue (HPQ) does not provide the precise priority levels of 802.1p
tagging, it does assign traffic as either high or low priority and sends high priority
packets first. Therefore, if there are multiple applications on a system sending
106
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674