IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 105 / 192

Note: The Devices and I/O Ports choice appears only on the full configuration
menu. If you set two levels of passwords, you must enter the
administrator password to access the full configuration menu.
4.
Select the serial port; then, use the arrow keys to advance through the settings
available.
5. Select Save Settings ; then select Exit Setup to exit from the
Configuration/Setup Utility main menu.
Serial-port connector: The following table shows the pin-number assignments for
the 9-pin, male D-shell serial-port connector on the rear of your computer. These
pin-number assignments conform to the industry standard.
1 5
6 9
Table 15. Serial-port connectors pin-number assignments
Pin Signal Pin Signal
1 Data carrier detect 6 Data set ready
2 Receive data 7 Request to send
3 Transmit data 8 Clear to send
4 Data terminal ready 9 Ring indicator
5 Signal ground
Universal Serial Bus ports
Your computer has two Universal Serial Bus (USB) ports, which configure
automatically. USB is an emerging serial interface standard for telephony and
multimedia devices. It uses Plug and Play technology to determine the type of
device attached to the connector.
Notes:
1. If you attach a standard (non-USB) keyboard to the keyboard connector, the
USB ports and devices will be disabled during the power-on self-test (POST).
2. If you install a USB keyboard that has a mouse port, the USB keyboard
emulates a mouse and you will not be able to disable the mouse settings in the
Configuration/Setup Utility program.
USB cables and hubs: You need a 4-pin cable to connect devices to USB 1 or USB
2. If you plan to attach more than two USB devices, you must use a hub to connect
the devices. The hub provides multiple connectors for attaching additional external
USB devices.
USB technology provides up to 12 megabits-per-second (Mbps) speed with a
maximum of 127 external devices and a maximum signal distance of five meters
(16 ft). per segment.
Installing options
97