IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 63 / 192

“Removing the cover” on page 48 for instructions.
Cover release
lever
Screws
4.
Remove the expansion slot clip that holds the expansion slot cover in place by
sliding it upward and off the frame of the computer.
Note: The illustrations in this document might differ slightly from your
hardware.
Retention
latch
Tab
Adapter
cards
Expansion
slot cover
Expansion
slot clip
Expansion
slot
5. Remove the expansion-slot cover.
6.
Refer to the documentation that comes with your adapter for any cabling
instructions.
Attention: You should route adapter cables before you install the adapter.
7. Set any jumpers or switches as described by the adapter manufacturer.
8. Install the adapter:
Note: When installing an adapter in PCI slot 2, skip steps a and d.
a. Open the adapter retention latch by pushing the blue tab to release it.
Then push the latch up to the full open position.
b. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the PCI riser-card.
Installing options
55