IBM 867413x - Eserver xSeries 330 8674, Hardware Maintenance Manual

Page: 119 / 192

b. Connect the opposite end of the C2T chaining cable to the C2T (In) port of
the server below it.
c.
Repeat these steps until all of the servers are connected together.
d. Connect the C2T breakout cable to the C2T (Out) port of server 1.
In
In Out
Out
Out
Out
In
In
Mouse
Keyboard
Video
4
3
2
1
Note: Server 1 (usually the server at the bottom of the rack) is the server to
which you connect the device breakout cable.
3. Turn on the servers; then, check the operation of the monitor, pointing device,
and keyboard with each server. (See “Testing the
C2T chain” for testing
instructions.)
Note:
Write-on adhesive labels have been provided so that you can label the
positions of the servers in the rack.
Testing the C2T chain
After connecting the C2T chain, you will need to test the monitor, keyboard, and
pointing device to be sure that they work with each of the servers.
Follow these steps to test the C2T cabling:
1. Turn on all the servers and the monitor and verify that the light in the Select
button on server 1 in the C2T chain is lit, indicating that it is selected. If it is
not, press the Select button.
2. Verify that the monitor is working.
3.
Start up an operating system that has a mouse or pointing device driver and
verify that the mouse or pointing device buttons function.
4. Test your keyboard by typing a few words within an application.
5.
Press NumLock on the keyboard twice, and then press the number of the
server to test next, and then press Enter. Repeat steps 1 through 4 for each of
the servers in the chain.
Note: If you cannot use the devices, check your cable connections and retry the
test. If the problem persists, turn off the servers and connect the C2T
Installing options
111