Chapter 8. Physical Characteristics of the 7200 Series
This chapter provides the physical characteristics for the 7200 series of external devices. The following
information can help you plan for your external devices. This section also gives the physical characteristics
for the 4869 Model 002 5 1/4-inch 1.2MB external diskette drive. You need only do physical planning for
the devices you have ordered.
Note:
Footprints are not drawn to scale. Where a footprint is shown, the figure represents a top view of
the device.
7202 Model 900 Expansion Rack
Dimensions
Height
1578 mm
62.0 in.
Width
650 mm
25.5 in.
Depth
921 mm
36.0 in.
Weight
Minimum
136 kg
300 lbs.
Maximum
470 kg
1035 lbs.
Electrical
¹
Power source loading
0 .004
(typical in kVA)
Voltage range (V ac)
200 to 240 or -48V dc
Frequency (hertz)
50 or 60
Thermal output (typical)
15 Btu/hr
Power requirements (typical)
4 watts
Power factor
0.5 to 0.7
Maximum altitude
2135 m (7000 ft.)
Temperature Requirements
Operating
10 to 40°C
(50 to 104°F)
Non-Operating
10 to 52°C
(50 to 125°F)
Humidity Requirements
Operating
Non-Operating
(Noncondensing)
8 to 80%
8 to 80%
Wet Bulb
27°C (80°F)
27°C (80°F)
Noise Emissions
²³
Operating
Idle
L
WAd
6.2 bels
6.0 bels
L
pAm
N/A
N/A
<L
pA
>
m
48 dBA
46 dBA
Impulsive or prominent discrete tones
No
No
Clearances
Front
Back
Left
Right
Install/Air Flow
Maintenance of a proper service clearance should allow proper air flow.
Service
1650 mm(65 in)
760 mm(30 in)
915 mm(36 in)
915 mm(36 in)
1. No features installed.
2. See “Noise Emission Notes” on page 336 for definitions of emissions positions.
3. Noise emissions data for the 7202 Model 900 is based on the following configuration:
v
two 9334 Model 10 Drawers with two disk drives in each and
v
two 9334 Model 10 Drawers with three disk drives in each.
279
Summary of Contents for 7012 397
