Figure 10-3
Modifying ONU password on the web page
l
(Optional) Bind the alarm profile to the ONU.
The default profile 1 is used in this example.
huawei(config-if-gpon-0/1)#
ont alarm-profile 0 1 profile-id 1
Step 3
Check ONU status.
After an ONU is added, run the
display ont info
command to query the current status of the
ONU. Ensure that
Config flag
of the ONU is
active
,
Run State
is
online
,
Config state
is
normal
, and
Match state
is
match
.
huawei(config-if-gpon-0/1)#
display ont info 0 1
---------------------------------------------------------------------
F/S/P : 0/1/0
ONU-ID : 1
Control flag :
active
//Indicates that the ONU is
activated.
Run state :
online
//Indicates that the ONU goes online
successfully.
Config state :
normal
//Indicates that the configuration state of the
ONU is normal.
Match state :
match
//Indicates that the capability profile bound to
the ONU is consistent with the actual capability of the ONU.
...//The rest of the response information is omitted.
When
Config state
is
failed
,
Run state
is
offline
, or
Match state
is
mismatch
:
l
If
Control flag
is
deactive
, run the
ont active
command in GPON mode to activate the ONU.
l
If
Run state
is
offline
, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
l
If
Config state
is
failed
, the configured ONU capability exceeds the actual ONU capability.
In this case, run the
display ont failed-configuration
command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
----End
10.6.1.4 Configuring a VDSL2 User Port
Services can be transmitted only after a VDSL2 port is activated on an optical network unit
(ONU). This section describes how to activate a VDSL2 port and bind a VSDL2 line profile to
the port.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
10 FTTD Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
747
