> Please set the channel-profile index (1~128) [1]:
10
Add template 10 successfully
4.
Configure the VDSL2 alarm profile.
You can configure the VDSL2 alarm profile based on your requirements. For the
configuration, see "Configuring a VDSL2 Alarm Template". In this example, the default
alarm profile 1 is used.
5.
Configure the VDSL2 traffic profile.
You can configure the VDSL2 traffic profile by running the
traffic table ip
command
based on your requirements.
In this example, the default profile (profile 6) is used.
6.
Activate the VDSL2 port.
huawei(config)#
interface vdsl 0/2
huawei(config-if-vdsl-0/2)#
alarm-config all
huawei(config-if-vdsl-0/2)#
activate all template-index 10
huawei(config-if-vdsl-0/2)#
quit
7.
Configure the upstream port.
l
Configure the GIU board.
In general, the GE optical port uses the default gigabit full-duplex mode.
To change the mode, switch to the GIU config mode. Then run the
speed
command
to change the port rate, and run the
duplex
command to change the port duplex mode.
The settings of the upstream port must be the same as the settings on the peer device.
l
Configure the VLAN.
The VDSL2 users of MA5600T-1 use the PPPoE authentication. In this case, the
smart VLAN is used to identify the users.
huawei(config)#
vlan 1800 smart
huawei(config)#
port vlan 1800 0/19 0
8.
Add the service port.
All ports in slot 0/2 provide the VDSL2 Internet access service. To add service ports in
batches, run the
multi-service-port
command.
huawei(config)#
multi-service-port vlan 1800 port 0/2 0-23 vpi 0 vci 35 user-
encap
pppoe rx-cttr 6 tx-cttr 6
Step 7
Configure the QinQ private line service.
MA5600T-4 and MA5600T-1 serve two branches of a company to provide the QinQ private
line service.
1.
Create VLAN 50.
huawei(config)#
vlan 50 mux
2.
Set VLAN 50 as QinQ VLAN.
huawei(config)#
vlan attrib 50 q-in-q
3.
Add the upstream port.
huawei(config)#
port vlan 50 0/19 0
4.
Add the service port.
To add the service port, run the
service-port
command. Note that the VPI and VCI values
of the service port must be the same as those on the modem.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7 Example: Subtending Networking
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
541