l
Commission the outband network management on the U2000.
1.
Configure the gateway of the route from the U2000 to network segment 10.50.1.0/24
to 10.10.1.1.
–
In the Solaris OS, do as follows:
Run the
route add 10.50.1.0 10.10.1.1
command to add a route.
Run the
netstat -r
command to query the information about the current routing
table.
–
In the Windows OS, do as follows:
Run the
route add 10.50.1.0 mask 255.255.255.0 10.10.1.1
command to add a
route.
Run the
route print
command to query the information about the current routing
table.
NOTE
If the IP address of the outband network management port and the IP address of the U2000 are
in the same network segment, you need not configure the routing information.
2.
Log in to the U2000.
3.
Set the SNMP parameters. A default SNMP profile exists in the system. Use the default
profile in this service. If a new profile is required, do as follows:
a.
Choose
Administration
>
NE Communicate Parameter
>
Default Access
Protocol Parameters
from the main menu.
b.
–
When the SNMP V1 is used, choose
SNMP v1 Parameter
on the
Default
Access Protocol Parameters
tab page. Then click
Add
and set the SNMP
parameters, as shown in the following figure (the other parameters except
Profile name
use the default settings).
Figure 1-51
Set the SNMP parameters
–
When the SNMP V2 is used, choose
SNMP v2 Parameter
on the
Default
Access Protocol Parameters
tab page. Then click
Add
and set the SNMP
parameters, as shown in the following figure (the other parameters except
Profile name
use the default settings).
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
139
