huawei(config-if-vlanif8)#
ip address 192.168.50.1 24
huawei(config-if-vlanif8)#
quit
Step 5
Configure the inband management VLAN and IP address of the ONU.
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
ont ipconfig 1 1 static ip-address 192.168.50.2 mask
255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/3)#
quit
Step 6
Configure an inband management service port.
The management VLAN is VLAN 8, the GEM port ID is 11, and user VLAN is VLAN 8. The
OLT does not limit the rate of inband management services. Therefore, you can directly bind
default traffic profile 6 to the inband management service port.
huawei(config)#
service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 7
Check whether the management service port between the OLT and the ONU is available.
l
Run the
ping ONU ip
command on the OLT to check the connectivity between the OLT and
the ONU. If the ICMP ECHO-REPLY packets from the ONU are received, the connectivity
between the OLT and the ONU is in good condition.
l
If you can remotely log in to the ONU from the OLT to perform configurations for the ONU,
the management service port between the OLT and the ONU is available.
----End
Follow-up Procedure
When
Config state
is
failed
,
Run state
is
offline
, or
Match state
is
mismatch
:
l
If
Control flag
is
deactive
, run the
ont active
command in GPON mode to activate the
ONU.
l
If
Run state
is
offline
, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
l
If
Config state
is
failed
, the configured ONU capability exceeds the actual ONU capability.
In this case, run the
display ont failed-configuration
command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
l
If the ONU does not match, that is,
Match state
is
mismatch
, the port types and number
of ports undermatch the actual port types and number of ports supported by the ONU. In
this case, run the
display ont capability
command to query the actual capability of the
ONU, and then select one of the following modes to modify the ONU configuration:
–
Create a proper ONU profile according to the actual capability of the ONU, and then
run the
ont modify
command to modify the configuration data of the ONU.
–
Modify the ONU profile according to the actual capability of the ONU and save the
modification. Then, the ONU automatically recovers the configuration successfully.
14.4.4.4 Configuring the TDM Connection and TDM PW
A TDM connection between the OLT and ONU is created and bound to the PW, so that TDM
PWE3 services can be transmitted between two OLTs.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1454
