Step 4
Configure a service port.
Set the service port ID to 1, SVLAN ID to 300, GEM port ID to 12, and user VLAN ID to 300.
The ONU limits upstream and downstream traffic rates but the OLT does not. Therefore, use
default traffic profile 6.
The user VLAN must be the same as the upstream VLAN of the ONU.
huawei(config)#
vlan 300 smart
huawei(config)#
service-port 1 vlan 300 gpon 0/3/1 ont 1 gemport 12 multi-service
user-vlan 300 rx-cttr 6 tx-cttr 6
----End
13.3.5.6 Configuring ONU SAToP Connections
This topic describes how to configure a SAToP connection of the IP+UDP encapsulation type
and a service VLAN to enable packets of base stations to be encapsulated on ONUs as Ethernet
packets and then forwarded based on VLANs and MAC addresses.
Data Plan
Configurati
on Item
Data
EDTB (OLT)
Port: 0/5/0
Board IP address: 10.10.50.10
Board MAC address: dynamically obtained (
)
Local UDP port number: 50048 (
E1 port
(ONU)
Board IP address: 10.10.50.20
Board MAC address: dynamically obtained (
)
UDP port number: 50048 (
)
VLAN
SVLAN: 300
Remark 1: MAC address configuration modes (statically configured or dynamically obtained)
at two ends must be consistent to establish a SAToP connection. It is recommended that MAC
addresses be dynamically obtained, which facilitates configuration and maintenance.
Remark 2: The UDP port cannot be a port that is widely used in the industry and for specific
services. For example, port 80 is used for HTTP service. The dynamic and private ports are
recommended.
Procedure
Step 1
Configure a VLAN and add an upstream port to the VLAN.
Create the upstream VLAN 300, and add upstream port 0/0/1 to VLAN 300.
huawei(config)#
vlan 300 smart
huawei(config)#
port vlan 300 0/0 1
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
13 FTTO Configuration (Large-sized Enterprise Access)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1336
