huawei(config-if-h248-0)#
tid-format pstn prefix huawei template 6
Step 6
Enable the MG interface.
Reset the MG interface to make the MG interface register with the MGC (or to make the attributes
of the MG interface take effect), so that the MG interface can work in the normal state. The MG
interface can be enabled in different ways (see Parameters of the
reset
command). For a newly
configure MG interface, enable the MG interface through cold start.
huawei(config-if-h248-0)#
reset coldstart
Are you sure to reset MG interface?(y/n)[n]:
y
huawei(config-if-h248-0)#
quit
Step 7
Query the running status of the MG interface.
After the MG interface is interconnected with the MGC, the MG interface should be in the normal
state, indicating that the MG interface can work in the normal state.
huawei(config)#
display if-h248 all
-------------------------------------------------------------------------
MGID TransMode State MGPort MGIP/DomainName MGCPort MGCIP/DomainName
-------------------------------------------------------------------------
0 UDP Normal 2944 10.10.10.10 2944 10.10.20.20
-------------------------------------------------------------------------
Step 8
Confirm the service board.
Confirm the ASPB board that carries services to ensure that the board can work in the normal
state.
huawei(config)#
board confirm 0/3
Step 9
Configure the PSTN user data.
Add POTS users (phones 0-31) to ensure that users can go online.
huawei(config)#
esl user
huawei(config-esl-user)#
mgpstnuser batadd 0/3/0 0/3/31 0
huawei(config-esl-user)#
quit
Step 10
Configure the polarity reversal accounting function.
Configure the physical attributes of the PSTN port to which the users belong to support the
polarity reversal pulse, so that the users can support the polarity reversal accounting.
huawei(config)#
pstnport
huawei(config-pstnport)#
pstnport attribute batset 0/3/0 0/3/31 reverse-pole-pulse
enable
huawei(config-pstnport)#
quit
Step 11
Save the data.
huawei(config)#
save
----End
Result
After the interface data and the PSTN user data corresponding to the MG interface are configured
on the MGC, check whether the VoIP services can be provisioned normally. In the normal state,
phones 0-31 can make phone calls to each other:
l
The caller can hear the dial tone after picking up the phone.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3 Configuring the DSLAM Services
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
307
