iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
242
Step 8
After the connection test is successful, click
in the toolbar to save the device
information.
----End
6.5 Scenarios for Connecting the ECC800 Collector
6.5.1 Commissioning Southbound Devices of ECC800
For details, see commissioning chapter in ECC800 Data Center Controller User Manual.
6.5.2 Setting and Adding the ECC800 Collector
The requirements for ECC800 WebUI login are as follows.
Computer operating system: Windows 7 and later versions
Browser: IE9 and later versions; Firefox and later versions; Chrome and later versions
6.5.2.1 Setting NetEco Parameters
When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1
Apply for a fixed IP address to the equipment room network administrator.
Step 2
Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 6-45
IP parameters
Path
Parameter
Default
Value
Setting Value
System
Settings
>
System
Parameters
>
Monitor
Module
IP
>
WAN_1
IP
192.168.1.10
Set this parameter based on the IP address
assigned by the network administrator.
Subnet mask
255.255.255.
0
Set this parameter based on the subnet mask
assigned by the network administrator.
Default
gateway
192.168.1.1
Set this parameter based on the default
gateway address assigned by the network
administrator.
Step 3
Set NetEco communications parameters on the ECC800 WebUI.
Table 6-46
NetEco parameters
Path
Parameter
Default
Value
Setting Value
