REMEMBER!
To leave the
Programming Mode at
any time, press the
Esc
key. Doing so will
return the CP-220A to
its normal operating
mode. Programming
changes will be stored
automatically.
•
The account must be programmed with the phone number
corresponding to the Line Card in
Slot 8
of the CP-220A.
Two-Way Listen-In:
Listen-In
works like this: Once an account has transmitted its message (or
messages) to the CP-220A, the CP-220A produces the appropriate
kissoff
signal informing the account that its message has been received (see
Section
1: Getting Acquainted)
. Because it's a
Listen-In
account, both the account
and the CP-220A keep the line open for the period of time that is specified in
this parameter. While Line Card 8 is actively in the
Listen-In
mode, all
on-premises noises can be heard via the CP-220A's front panel speaker. The
volume control adjacent to the speaker can be used at this time to raise or
lower the
Listen-In
audio level. For purposes of privacy or to avoid ambient
noises, a headset can be plugged into the front panel's headset jack.
Line Card 8 will not accept any incoming calls while in the Listen-In mode.
The Listen-In call can be terminated at any point within this time period by
depressing the
N
key momentarily.
Programming Procedures:
A range from 00 seconds to 90 seconds, in 10-second increments, can be set
through the use of this parameter. After entering
PARAMETER 32,
[LISTEN TIME 90 SEC] will be displayed and the [9] will be flashing. If
necessary, use the appropriate numeric key to change the first digit. The
second digit is fixed at [0] and cannot be changed.
Default:
The CP-220A has been factory programmed with a
Listen-In
time of 90
seconds.
Advancing to Next Parameter:
After programming
PARAMETER 32,
press the
N
key to advance to
PARAMETER 33
– the next parameter in
Category A.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 32]) with its first digit flashing, indicating its request for the next
parameter number. You can reach
PARAMETER 33
in one of several ways.
Press either:
•
3
then
3
, or
•
then
3
, or
• the
key
NOTE: When the
is used, the
name
of the next parameter appears
immediately – not its
number
.
CP-220A Central Station Receiver Section 2: Programming the CP-220A Page 2-35
Hook-Up and Installation Manual
