REMEMBER!
To leave the
Programming Mode
at any time, press
the
Esc
key. Doing
so will return the
CP-220A to its
normal operating
mode. Programming
changes will be
stored automatically.
Programming Procedures:
After entering
PARAMETER 26,
[SET TIME] will be displayed and the first
digit of the
month
field will be flashing. If it is necessary to set or change the
either the
date
, or the
time
, or
both,
use the following procedure. Note that,
if applicable, leading zeroes are required in both the
date
and
time
fields.
1. Enter the appropriate 1st digit of the month or use the
to advance to
the 2nd digit; in either case, the 2nd digit will begin flashing.
2. Repeat this process for the five remaining digits in the
date
, as required.
3. Continue in the same manner with the
time
by setting the hours,
minutes, and seconds using keyboard entries or by pressing the
key;
if an error is made, use either the
or the
key to move the flashing
cursor to the correct position.
4. Exit PARAMETER 26, either through the
key, the
key, the
N
key,
or the
Esc
key. The date/time clock begins counting as soon as
PARAMETER 26
is exited, making it easy to synchronize the CP-220A's
clock display with an accurate time source.
Illegal entries (e.g., [Date] 15/34/95 or [Time] 24:65:00) will be rejected by
the CP-220A and will revert to the defaults (see below) when exiting
PARAMETER 26.
Once the date/time is set, the extra day in February during leap years is
automatically accounted for, but automatic switching between standard time
and daylight savings time is not. These changes will have to be made
manually using the above procedures.
The CP-220A will maintain the correct date and time as long as power is
supplied to it – either via its connection to commercial electricity, or to its
standby battery, or both.
Default:
The time and date defaults are 01/01/00 and 00:00:00, respectively, which
are restored whenever all power to the CP-220A is removed.
Advancing to Next Parameter:
The next parameter in
Category A
is
PARAMETER 28.
Because it is not
sequential, it cannot be reached with a single press of the
key. To advance
to
PARAMETER 28
, press the
N
key.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 26]) with its first digit flashing, indicating its request for the next
parameter number. Press either:
•
2
then
8
, or
• the
key twice
NOTE: When the
is used, the
name
of the next parameter appears
immediately – not its
number
.
Page 2-18 Section 2: Programming the CP-220A CP-220A Central Station Receiver
Hook-Up and Installation Manual
