Programming Procedures:
1. Note that after entering
PARAMETER 27,
[CHANNEL 1 CHAN ONE]
appears on the display and [CHANNEL 1] is flashing. To program
descriptive words for
Channel 1,
proceed to the next step. To select
another channel, press the key (between 2 and 8) representing the
desired channel.
2.
Press the
once to advance the flashing cursor to the [C], which is part
of the [CHAN] designation. To change the word, press the
NEXT
key –
one push at a time. Doing so takes the first character incrementally
through the following sequence of characters, which repeats itself:
• letters of the alphabet
•
blank
space
• numbers 0 through 9
NOTE 1: The
MANUAL/PREVIOUS
key may be pushed momentarily to
move backward through the set of characters if it's easier to
reach the desired selection that way.
NOTE 2: If the
NEXT
or the
MANUAL/PREVIOUS
keys are held down
rather than released after being depressed, it's possible to
scroll forward or backward through the selections in
increments of approximately 5 characters at a time.
3. When the appropriate character is displayed, press the
to move the
cursor to the next letter. Once again, use the
NEXT
key or the
MANUAL/PREVIOUS
key, as described, to select the desired character.
4. Repeat this process until the custom word is complete. A total of 12
characters (letters, numbers, and/or spaces) may be programmed for
words used to represent each of the eight channels in this format.
5. Press
the as required until the
Channel Number
flashes. To select
another Channel Number, press the appropriate key (between 1 and 8).
6
Repeat Steps 2 through 5 to program additional descriptive words.
NOTE 1: Unlike
PARAMETER 28,
in which descriptive wording had to
be programmed on a Line Card-by-Line Card (i.e., Slot-by-
Slot) basis, entries made in
PARAMETER 30
are global and
will be valid for any Line Card that receives a message in the
ADEMCO High Speed (Superfast)
format.
NOTE
2: Even if programmed, the use of
Channel English
can
subsequently be "turned off" through the use of
PARAMETER
30,
which was discussed on page 2-28.
NOTE 3: Refer to
Appendix B
for important additional information on
how the CP-220A processes subscriber transmissions in this
format.
CP-220A Central Station Receiver Section 2: Programming the CP-220A Page 2-31
Hook-Up and Installation Manual
